AVM FRITZ!Repeater 3000 default password & login IP
The AVM FRITZ!Repeater 3000 ships with a unique password printed on the device label, not a shared default — log in at http://fritz.repeater.
- Login address
- http://fritz.repeater
- Username
- — none —
- Password
- — on the device label —
The password is unique to your unit and printed on a sticker on the router (often labelled Password or Access Key).
A tri-band step up from this run's 600, carrying AVM's older (pre-Wi-Fi 6) higher-throughput repeater chipset. AVM's knowledge base documents the identical credential mechanism across the FRITZ!Repeater line: "either protected with a unique password in the factory settings or you must assign your own," with that factory value "located on the type label ... one word with 4 to 6 lower-case letters, followed by 4 numerals."
Factory reset
Type http://fritz.repeater into any browser; this address resolves locally even with no internet. Asked for a password? It's the code on the 3000's bottom label — a single lowercase word followed by four digits, no symbols. Missing or wrong? Create a fresh password right there on first access, or reuse whatever your Mesh Master already has set. A full wipe happens via the UI's System > Backup > Factory settings page, or the unit's physical reset button, after which the same login steps apply again.
More AVM models
- AVM FRITZ!Box 7590
- AVM FRITZ!Box 7590 AX
- AVM FRITZ!Box 7530
- AVM FRITZ!Box 7530 AX
- AVM FRITZ!Box 7490
- AVM FRITZ!Box 5590 Fiber
- AVM FRITZ!Box 6660 Cable
- AVM FRITZ!Box 4060
FAQ
- What is the default password for the AVM FRITZ!Repeater 3000?
- The AVM FRITZ!Repeater 3000 ships with a unique password printed on the device label, not a shared default — log in at http://fritz.repeater.
- What is the default login IP for the AVM FRITZ!Repeater 3000?
- The AVM FRITZ!Repeater 3000 admin page is reached at http://fritz.repeater, not a raw IP address.
- How do I factory-reset the AVM FRITZ!Repeater 3000?
- Type http://fritz.repeater into any browser; this address resolves locally even with no internet. Asked for a password? It's the code on the 3000's bottom label — a single lowercase word followed by four digits, no symbols. Missing or wrong? Create a fresh password right there on first access, or reuse whatever your Mesh Master already has set. A full wipe happens via the UI's System > Backup > Factory settings page, or the unit's physical reset button, after which the same login steps apply again.
Verification history (2)
Every time we've checked this model's default credentials, oldest first — including when nothing changed. Absence of change over time is itself the evidence.