TP-Link Archer BE800 (BE19000)

Default access and factory-reset steps, cited to the manufacturer.

For regaining access to a router you own or administer. If you didn't set it up, ask whoever did.

Login address: http://tplinkwifi.net
Gateway IP: 192.168.0.1
Username: — none —
Password: — no default —

You create this password the first time you set up the router. If you never changed it, factory-reset and set a new one.

Modern Archer firmware forces you to create an admin password on first login — there is no admin/admin default. The default Wi-Fi network name and password are printed on the label on the bottom of the router.

Factory reset

With the router powered on, use a pin to press and hold the recessed Reset button for about 10 seconds until the LEDs change, then release. The router reboots to factory defaults. Reconnect to the default Wi-Fi (SSID and password on the bottom label), open http://tplinkwifi.net or 192.168.0.1, and create a new admin password when prompted.

Source: TP-Link Official Support — How to log in to the web management pageverified · medium confidence · updated 2026-07-13

Identify a device by MAC →Report an error →